Máy Lọc Nước Siêu Sạch Kiểu R

Máy lọc nước siêu sạch dòng R sản xuất nước siêu tinh khiết đáp ứng các yêu cầu của PN-EN ISO 3696: 1999 đối với nước cấp độ một và EP. Chúng có khả năng tự động hóa rộng rãi cho phép giám sát công việc ở các giai đoạn chuyển giao được chọn, lưu trữ dữ liệu, cài đặt riêng các ngưỡng báo động, kiểm soát chức năng của các kết nối màng phẳng và chỉ báo mức nội dung.

 

---

R5

Cat. no: 5DR-TOC-00

– Fed by tap water.

– Qui trình lọc nước siêu sạch :

• sediment pre-filter 5µm,
• integrated module (sediment-carbon-softening),
• demineralization on an spectrally clean ion-exchange TOC bed,
• reverse osmosis,
• UV lamp 254 nm,
• microfiltration capsule 0,45/0,2μm.

– Công suất thiết bị tối thiểu . 5-7 dm3/h.

– Độ dẫn của nước khử khoáng < 0,06 μS/cm.

– Tiêu chuẩn nước lọc theo  (PN-EN ISO 3696:1999, ASTM, EP). 

– Nước thu được có thể được sử dụng cho các phân tích công cụ AAS, ICP / MS, IC, HPLC, GC, nuôi cấy vi khuẩn, phân tích sinh hóa. 

– Hệ thống được tích hợp với tank chứa lên đến 10 dm3 .

– Tự động tuần hoàn nước siêu tinh khiết .

– Nhiệt độ làm mát : 5-40ºC.

– Nguồn cấp : 230V/50Hz.

---

R5 UV

Cat. no: 5DR-TOC-UV

- Nước cấp bằng nước máy.

- Các cấp độ của quá trình lọc nước:

Bộ lọc trước trầm tích 5µm,
Mô-đun tích hợp (làm mềm trầm tích-carbon),
Khử khoáng trên giường TOC trao đổi ion quang phổ sạch, thẩm thấu ngược,
Đèn UV 185/254 nm, màng lọc loại 0,45 / 0,2μm.
- Hiệu suất thiết bị tối thiểu. 5-7 dm3 / h.

- Độ dẫn nước khử khoáng <0,55 μS / cm.

- Điểm thu nước - cấp độ tinh khiết lọai I (PN-EN ISO 3696: 1999, ASTM, EP).

- Nước thu được có thể được sử dụng cho các máy phân tích  AAS, ICP / MS, IC, HPLC, GC, nuôi cấy vi khuẩn, phân tích sinh hóa.

- Hệ thống trang bị bình tích áp 10 dm3.

- Tự động tuần hoàn nước siêu tinh khiết giữa các bộ sưu tập nước.

- Nước cấp bằng nước lạnh: 5-40ºC.

- Nguồn điện: 230V / 50Hz.

---

R5 UF

Cat. no: 5DR-TOC-UF 

– Fed by tap water.

– Water purification process levels:

• sediment pre-filter 5µm,
• integrated module (sediment-carbon-softening),
• demineralization on an spectrally clean ion-exchange TOC bed,
• reverse osmosis,
• UV lamp 185/254 nm,
• ultrafiltration UF,
• microfiltration capsule 0,45/0,2μm.

– Device efficiency min. 5-7 dm3/h.

– Demineralized water conductivity < 0,55 μS/cm.

– Water collection point – I purity class (PN-EN ISO 3696:1999, ASTM, EP). 

– Obtained water may be used for instrumental analyses AAS, ICP/MS, IC, HPLC, GC, bacteria cultures, biochemical analyses, molecular biology, PCR.

– System equipped with a 10 dm3 pressure storage tank.

– Automatic ultrapure water recirculation between water collections.

– Fed by cold water: 5-40ºC.

– Power supply: 230V/50Hz.

---

R10

Cat. no: 10DR-TOC-00

– Fed by tap water.

– Water purification process levels:

• sediment pre-filter 5µm,
• integrated module (sediment-carbon-softening),
• demineralization on an spectrally clean ion-exchange TOC bed,
• reverse osmosis,
• UV lamp 254 nm,
• microfiltration capsule 0,45/0,2μm.

– Device efficiency min. 10-12 dm3/h.

– Demineralized water conductivity < 0,55 μS/cm.

– Water collection point – first purity class ((PN-EN ISO 3696:1999, ASTM, EP). 

– Obtained water may be used for instrumental analyses AAS, ICP/MS, IC, HPLC, GC, bacteria cultures, biochemical analyses. 

– System equipped with a 10 dm3 pressure storage tank.

– Automatic ultrapure water recirculation between water collections.

– Fed by cold water: 5-40ºC.

– Power supply: 230V/50Hz.

---

R10 UV

Cat. no: 10DR-TOC-UV

– Fed by tap water.

– Water purification process levels:

• sediment pre-filter 5µm,
• integrated module (sediment-carbon-softening),
• demineralization on an spectrally clean ion-exchange TOC bed,
• reverse osmosis,
• UV lamp 185/254 nm,
• microfiltration capsule 0,45/0,2μm.

– Device efficiency min. 10-12 dm3/h.

– Demineralized water conductivity < 0,55 μS/cm.

– Water collection point – I purity class (PN-EN ISO 3696:1999, ASTM, EP). 

– Obtained water may be used for instrumental analyses AAS, ICP/MS, IC, HPLC, GC, bacteria cultures, biochemical analyses. 

– System equipped with a 10 dm3 pressure storage tank.

– Automatic ultrapure water recirculation between water collections.

– Fed by cold water: 5-40ºC.

– Power supply: 230V/50Hz.

---

R10 UF

Cat. no: 10DR-TOC-UF

– Fed by tap water.

– Water purification process levels:

• sediment pre-filter 5µm,
• integrated module (sediment-carbon-softening),
• demineralization on an spectrally clean ion-exchange TOC bed,
• reverse osmosis,
• UV lamp 185/254 nm,
• ultrafiltration UF,
• microfiltration capsule 0,45/0,2μm.

– Device efficiency min. 10-12 dm3/h.

– Demineralized water conductivity < 0,55 μS/cm.

– Water collection point – I purity class (PN-EN ISO 3696:1999, ASTM, EP). 

– Obtained water may be used for instrumental analyses AAS, ICP/MS, IC, HPLC, GC, bacteria cultures, biochemical analyses, molecular biology, PCR.

– System equipped with a 10 dm3 pressure storage tank.

– Automatic ultrapure water recirculation between water collections.

– Fed by cold water: 5-40ºC.

– Power supply: 230V/50Hz.

---

R20

Cat. no: 20DR-TOC-00

– Fed by tap water.

– Water purification process levels:

• sediment pre-filter 5µm,
• integrated module (sediment-carbon-softening),
• demineralization on an spectrally clean ion-exchange TOC bed,
• reverse osmosis,
• UV lamp 254 nm,
• microfiltration capsule 0,45/0,2μm.

– Device efficiency min. 20-22 dm3/h.

– Demineralized water conductivity < 0,55 μS/cm.

– Water collection point – first purity class ((PN-EN ISO 3696:1999, ASTM, EP). 

– Obtained water may be used for instrumental analyses AAS, ICP/MS, IC, HPLC, GC, bacteria cultures, biochemical analyses. 

– System equipped with a 10 dm3 pressure storage tank.

– Automatic ultrapure water recirculation between water collections.

– Fed by cold water: 5-40ºC.

– Power supply: 230V/50Hz.

---

R20 UV

Cat. no: 20DR-TOC-UV 

– Fed by tap water.

– Water purification process levels:

• sediment pre-filter 5µm,
• integrated module (sediment-carbon-softening),
• demineralization on an spectrally clean ion-exchange TOC bed,
• reverse osmosis,
• UV lamp 185/254 nm,
• microfiltration capsule 0,45/0,2μm.

– Device efficiency min. 20-22 dm3/h.

– Demineralized water conductivity < 0,55 μS/cm.

– Water collection point – I purity class (PN-EN ISO 3696:1999, ASTM, EP). 

– Obtained water may be used for instrumental analyses AAS, ICP/MS, IC, HPLC, GC, bacteria cultures, biochemical analyses. 

– System equipped with a 10 dm3 pressure storage tank.

– Automatic ultrapure water recirculation between water collections.

– Fed by cold water: 5-40ºC.

– Power supply: 230V/50Hz.

---

R20 UF

Cat. no: 20DR-TOC-UF

– Fed by tap water.

– Water purification process levels:

• sediment pre-filter 5µm,
• integrated module (sediment-carbon-softening),
• demineralization on an spectrally clean ion-exchange TOC bed,
• reverse osmosis,
• UV lamp 185/254 nm,
• ultrafiltration UF,
• microfiltration capsule 0,45/0,2μm.

– Device efficiency min. 20-22 dm3/h.

– Demineralized water conductivity < 0,55 μS/cm.

– Water collection point – I purity class (PN-EN ISO 3696:1999, ASTM, EP). 

– Obtained water may be used for instrumental analyses AAS, ICP/MS, IC, HPLC, GC, bacteria cultures, biochemical analyses, molecular biology.

– System equipped with a 10 dm3 pressure storage tank.

– Automatic ultrapure water recirculation between water collections.

– Fed by cold water: 5-40ºC.

– Power supply: 230V/50Hz.

---

R30

Cat. no: 30DR-TOC-00

– Fed by tap water.

– Water purification process levels:

• sediment pre-filter 5µm,
• integrated module (sediment-carbon-softening),
• demineralization on an spectrally clean ion-exchange TOC bed,
• reverse osmosis,
• UV lamp 254 nm,
• microfiltration capsule 0,45/0,2μm.

– Device efficiency min. 30-32 dm3/h.

– Demineralized water conductivity < 0,55 μS/cm.

– Water collection point – first purity class ((PN-EN ISO 3696:1999, ASTM, EP). 

– Obtained water may be used for instrumental analyses AAS, ICP/MS, IC, HPLC, GC, bacteria cultures, biochemical analyses. 

– System equipped with a 10 dm3 pressure storage tank.

– Automatic ultrapure water recirculation between water collections.

– Fed by cold water: 5-40ºC.

– Power supply: 230V/50Hz.

---

R30 UV

Cat. no: 30DR-TOC-UV

– Fed by tap water.

– Water purification process levels:

• sediment pre-filter 5µm,
• integrated module (sediment-carbon-softening),
• demineralization on an spectrally clean ion-exchange TOC bed,
• reverse osmosis,
• UV lamp 185/254 nm,
• microfiltration capsule 0,45/0,2μm.

– Device efficiency min. 30-32 dm3/h.

– Demineralized water conductivity < 0,55 μS/cm.

– Water collection point – I purity class (PN-EN ISO 3696:1999, ASTM, EP). 

– Obtained water may be used for instrumental analyses AAS, ICP/MS, IC, HPLC, GC, bacteria cultures, biochemical analyses. 

– System equipped with a 10 dm3 pressure storage tank.

– Automatic ultrapure water recirculation between water collections.

– Fed by cold water: 5-40ºC.

– Power supply: 230V/50Hz.

---

R30 UF

Cat. no: 30DR-TOC-UF

– Fed by tap water.

– Water purification process levels:

• sediment pre-filter 5µm,
• integrated module (sediment-carbon-softening),
• demineralization on an spectrally clean ion-exchange TOC bed,
• reverse osmosis,
• UV lamp 185/254 nm,
• ultrafiltration UF,
• microfiltration capsule 0,45/0,2μm.

– Device efficiency min. 30-32 dm3/h.

– Demineralized water conductivity < 0,55 μS/cm.

– Water collection point – I purity class (PN-EN ISO 3696:1999, ASTM, EP). 

– Obtained water may be used for instrumental analyses AAS, ICP/MS, IC, HPLC, GC, bacteria cultures, biochemical analyses, molecular biology, PCR.

– System equipped with a 10 dm3 pressure storage tank.

– Automatic ultrapure water recirculation between water collections.

– Fed by cold water: 5-40ºC.

– Power supply: 230V/50Hz.